Brine Shrimp Eggs Incubator 380ml Plastic Aquarium Artemia Eggs Hatchery Kit Fish Tank Shrimp Breeding Hatcher

Description

Description: Brine Shrimp Eggs Incubator 380ml Plastic Aquarium Artemia Eggs Hatchery Kit Fish Tank Shrimp Breeding Hatcher
Specification:
Condition: 100% Brand New
Capacity: 380ml
Weight: Approx. 279g
Height: Approx. 28cm/11.02inch

Using instructions:
1. Inject the treated water to the standard water level in the incubator tank, and add about 10g kosher salt to pre-dissolve
2. The air pump is connected to the air inlet hole at the bottom of the incubator, and the air volume is adjusted to an appropriate amount. The ideal temperature is 28 ~ 30
3. Add about 3 to 5 g of shrimp eggs, can hatch smoothly after about 36 ~ 48 hours
4. Collection operation: after the eggs hatch, stop pumping and let stand for about 10 ~ 15 minutes. When the shrimps sink to the bottom and the shells float, the larvae of shrimps can be collected from the original air inlet (air adjusting valve) at the bottom of the incubator, and then the larvae can be fed
5. Please store them in the refrigerator. Applicable: dry, frozen shrimp eggs are applicable

Incubation steps:
1. Add water 300 ml
2. Add half teaspoon of sea salt
3. Add 1 – 2 tablespoons of shrimp eggs
4. Connect air pump to open distributor
5. Waiting to hatch
6. Turn off the distributor and pull out the trachea

Incubation temperature:
Shrimp eggs can hatch in the range of 7-30 , and the incubation speed is accelerated with the increase of temperature
The preference incubation temperatureis 25-30 .

Package Included:
1 x Check Valve
1 x Suction Cup Fixed Holder
1 x Shrimp Incubator

Notice:
1. Air supply port at the bottom of shrimp incubator, please adjust the air input. Too much or too little air input will affect the hatching time and survival rate of shrimp eggs. Please adjust the air input by air switch.
2. The air supply port at the bottom is connected with a simple check valve, which can effectively prevent water backflow in the incubator.